Roman Paces to Inches (passus to in)

1 Roman pace equals 58.26771654 inches (rounded).

1 Roman pace = 58.26771654 inches

How to convert Roman paces to inches

To convert Roman paces to inches, multiply the number of Roman paces by 58.26771654. The factor is rounded to 10 significant digits. To go the other way, multiply inches by 0.01716216216 (rounded).

inches = Roman paces × 58.26771654

Example: 10 Roman paces = 582.6771654 inches.

Approximate value. Standards for the Roman pace varied by place and period, so this converter uses the most commonly cited value. Treat results as estimates, not exact figures.

About these units

Roman Pace (passus)

Ancient RomanHistorical unit (no longer in standard use)Approximate value

Five Roman feet, about 1.48 m. A passus was a full stride, from the lift of one foot to the same foot landing again.

Counting a pace by both feet is the key to the Roman passus. Unlike a single step, it ran from the point where one heel leaves the ground to where that same heel lands again, so it covered two steps, each called a gradus. Marcus Vipsanius Agrippa is credited with fixing it at five Roman feet, which comes to about 1.48 m, the figure used here. The exact size depends on the foot, whose surviving measures vary by a few millimeters.

A thousand paces, mille passus, formed the Roman mile of about 1.48 km, and the English word mile descends from that phrase. Milestones along roads such as the Appian Way marked distances in this unit,. The pace also sat in a chain of units: ten feet made a decempeda, and 120 feet made an actus. In imperial terms the passus is a little under five feet.

1 Roman pace = 1.48 meters (approximately).

Sources: Wikipedia: Pace (unit); Wikipedia: Ancient Roman units of measurement

Inch (in)

US & ImperialCurrent unit

1/12 of a foot. Defined as exactly 25.4 millimeters since 1959, when the US and Commonwealth countries agreed a common international inch.

Latin uncia, meaning one-twelfth, is the root of both inch and ounce, and it passed into Old English as ynce. Roman measurers divided their foot into twelve unciae, and the English inch kept that twelfth. After 1066 an inch was reckoned as three barleycorns, and a 1324 statute attributed to Edward II spelled out the definition as three grains of barley, dry and round, placed end to end lengthwise. For centuries the inch was simply a twelfth of a foot, or a thirty-sixth of a yard, and the US and UK each kept their own copy of the standard yard.

Those copies differed slightly until the 1959 international agreement fixed the yard at exactly 0.9144 meter, which made the inch exactly 25.4 millimeters. The US adopted it in 1959 and the UK ratified it in 1963, effective 1964. Today the inch is still the customary unit in the United States and Canada, and the UK keeps it on road signs. Worldwide it also names display diagonals, wheel rims, tire codes and pipe sizes.

1 inch = 0.0254 meters (exactly).

Sources: Wikipedia: Inch; Wikipedia: Yard; NIST Guide to the SI, Appendix B.8: conversion factors

Related conversions

See all length units.