Roman Pace (passus)

Ancient RomanHistorical unit (no longer in standard use)Approximate value

Five Roman feet, about 1.48 m. A passus was a full stride, from the lift of one foot to the same foot landing again.

1 Roman pace = 1.48 meters (approximately).

Approximate value. Standards for the Roman pace varied by place and period, so this converter uses the most commonly cited value. Treat results as estimates, not exact figures.

About the Roman pace

Counting a pace by both feet is the key to the Roman passus. Unlike a single step, it ran from the point where one heel leaves the ground to where that same heel lands again, so it covered two steps, each called a gradus. Marcus Vipsanius Agrippa is credited with fixing it at five Roman feet, which comes to about 1.48 m, the figure used here. The exact size depends on the foot, whose surviving measures vary by a few millimeters.

A thousand paces, mille passus, formed the Roman mile of about 1.48 km, and the English word mile descends from that phrase. Milestones along roads such as the Appian Way marked distances in this unit,. The pace also sat in a chain of units: ten feet made a decempeda, and 120 feet made an actus. In imperial terms the passus is a little under five feet.

Sources: Wikipedia: Pace (unit); Wikipedia: Ancient Roman units of measurement

Roman Pace conversion chart

1 Roman pace expressed in every other length unit:

More Ancient Roman units

• Roman inch (uncia) (length)
• Roman foot (length)
• Roman cubit (length)
• Roman stadium (length)
• Roman mile (length)
• Roman league (length)
• Roman pound (libra) (weight & mass)
• Roman ounce (uncia) (weight & mass)
• cyathus (volume)
• sextarius (volume)
• congius (volume)
• modius (volume)
• amphora (volume)
• iugerum (area)
• lustrum (time)
• indiction (time)

All Ancient Roman units

Browse all length units.