Gigahertz to Degrees Per Second (GHz to °/s)

1 gigahertz equals 360,000,000,000 degrees per second exactly.

How to convert gigahertz to degrees per second

To convert gigahertz to degrees per second, multiply the number of gigahertz by 360,000,000,000. This factor is exact. To go the other way, multiply degrees per second by 2.777777778×10⁻¹² (rounded).

degrees per second = gigahertz × 360,000,000,000

Example: 10 gigahertz = 3,600,000,000,000 degrees per second.

About these units

Gigahertz (GHz)

Metric (SI)Current unit

One billion hertz. Modern processor clocks and Wi-Fi run at gigahertz frequencies.

On 6 March 2000, AMD demonstrated a processor passing the 1 GHz mark, a few days before Intel shipped 1 GHz systems, according to Wikipedia. After that, clock rates rose more slowly: Intel's 3 GHz Pentium 4 arrived in 2002, and later performance came more from design changes than raw speed, since higher clock rates produce more heat. The highest boost clock on a production processor is listed as 6.2 GHz for the Intel i9-14900KS in 2024.

A gigahertz is a billion hertz, the range known as microwaves. The most familiar example may be the kitchen: consumer microwave ovens typically run at 2.45 GHz, a band that is available for industrial, scientific and medical use worldwide. Percy Spencer of Raytheon discovered the heating effect in 1945 when a radar set melted a candy bar in his pocket, and Raytheon sold the first commercial oven, the Radarange, in 1947.

1 gigahertz = 1,000,000,000 hertz (exactly).

Sources: Wikipedia: Clock rate; Wikipedia: Microwave oven; Wikipedia: Gigahertz

Degree Per Second (°/s)

ScientificCurrent unit

One 360th of a hertz: one full turn in 360 seconds. A measure of rotation rate.

Motion sensors and camera gear tend to report turning speed in degrees per second, a unit that people can picture more readily than radians. Three-axis gyroscopes in phones, tablets and game controllers measure the rate of rotation in roll, pitch and yaw, and the rate is commonly given in these degrees. A full turn is 360 degrees, so a device spinning once each second registers 360 degrees per second.

Converting to frequency is a division by 360. One degree per second is 1/360 hertz, about 0.002778 Hz, the figure used here. In terms of angular velocity it equals pi divided by 180 rad/s, about 0.01745, and 6 degrees per second equals one revolution per minute. Degrees per second are not an SI unit, though the degree itself is accepted for use alongside the SI.

1 degree per second = 0.002777777778 hertz (approximately).

Sources: Wikipedia: Gyroscope; Wikipedia: Angular velocity; Wikipedia: Revolutions per minute

Related conversions

See all frequency units.